Codice: Seleziona tutto
[ 5898.431708] r8169 0000:03:00.0: eth0: link down
[ 5898.431776] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 6851.144641] ieee80211 phy0: START: tid 1 is not agg'able
Codice: Seleziona tutto
[ 5898.431708] r8169 0000:03:00.0: eth0: link down
[ 5898.431776] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 6851.144641] ieee80211 phy0: START: tid 1 is not agg'able
Questo sembra essere un bug del kernel nel driver brcmsmac, https://bugs.launchpad.net/ubuntu/+sour ... bug/889675manu90 ha scritto:Ciao a tutti, da dmesg mi viene rilevato questo erroreCosa significa? Premetto che la linea internet funziona.Codice: Seleziona tutto
[ 6851.144641] ieee80211 phy0: START: tid 1 is not agg'able
Codice: Seleziona tutto
ifconfig
eth0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether e8:11:32:9b:d7:69 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 16436
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 0 (Local Loopback)
RX packets 4 bytes 240 (240.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 4 bytes 240 (240.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.1.42 netmask 255.255.255.0 broadcast 192.168.1.255
inet6 fe80::21b:b1ff:fef7:153c prefixlen 64 scopeid 0x20<link>
ether 00:1b:b1:f7:15:3c txqueuelen 1000 (Ethernet)
RX packets 23362 bytes 25535715 (24.3 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 19821 bytes 2764003 (2.6 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0